200W Monocrystalline Solar Panel

The 200 W Di-Tec solar panel uses monocrystalline cells with PERC technology and multi-busbar (MBB) design. The rear passivation layer of the PERC cells reflects light not captured by the front back into the cell, reducing electron recombination losses and increasing yield for the same level of irradiance. The multi-busbar design reduces resistive losses and contributes to the module's mechanical strength.

The 3.2 mm ultra-white tempered glass has a very low iron content (Fe2O3 less than 150×10⁻⁶) and light transmission greater than 91%; the suede-effect coating reduces surface reflection. The rear enclosure is hermetically sealed with an IP67 protection rating, which protects the electrical components from dust and water. The structure withstands wind loads of up to 2400 Pa and snow loads of up to 5400 Pa. Connection to an MPPT or PWM charge controller is required for proper use.

• Maximum power (Pmax): 200 W
• Efficiency: 19.74%
• Voltage at Pmax (Vmp): 20.20 V
• Current at Pmax (Imp): 9.41 A
• Open-circuit voltage (Voc): 24.0 V
• Short-circuit current (Isc): 10.76 A
• Cell type: monocrystalline PERC with multi-busbar (MBB) design
• Glass: 3.2 mm ultra-white tempered glass, Fe2O3 <150×10⁻⁶, transmission >91%
• Protection: IP67
• Operating temperature: from -40 °C to +85 °C
• NOCT: 45 ± 2 °C
• Wind resistance: up to 2400 Pa
• Snow load resistance: up to 5400 Pa
• Controller required: MPPT or PWM
• Dimensions: 1325 x 765 x 30 mm
• Weight: 10.50 kg
• EAN: 8059869079223